Biogas-Plant/C4/Maintenance-and-Repair/English

From Script | Spoken-Tutorial
Revision as of 13:22, 20 May 2016 by Bellatony911 (Talk | contribs)

Jump to: navigation, search
Visual Cue
Narration
Slide 1


Maintenance and Repair of the Biogas plant.

Hello and Welcome to the Spoken Tutorial on Maintenance and Repair of the Biogas plant.
Slide 2

Learning Objective


We will learn:


Different techniques to repair and maintain

  • the Biogas burner and
  • the Biogas plant


In this tutorial we will learn:


Different techniques to maintain and repair-

  • the Biogas plant and
  • the Biogas burner


Slide 3 Periodic partial and complete cleaning of the Biogas plant is a must.


This will ensure that the Biogas plant runs smoothly.


It will also ensure efficient working of the Biogas plant for many years.

Slide 4

Maintenance section

Let us first look into the maintenance section.
Slide 5


How often should one carry out maintenance of the Biogas plant?

So, how often should one carry out maintenance of the Biogas plant?
Slide 6


  • Always, mix the bio-waste with water in the proper ratio.
  • This will ensure-
    smooth flow of the bio-waste from the mixing tank into the digester tank.


Maintenance should be carried out on a daily basis by doing the following-


  • Always, mix the bio-waste with water in the proper ratio.
  • This will ensure-
  • smooth flow of the bio-waste from the mixing tank into the digester tank.


Slide 7 * If adding plant waste, crush and chop the leaves up to 1-4 cms.
  • Do not feed too much straw into the digester tank as it is difficult to be digested.
  • Sticks and branches of trees should also be avoided.


Slide 8 * Soap, oil, chemical, insecticide and pesticides should not be added.
  • Soil, sand or stone should also not be added.
  • As they will accumulate at the base of the digester and hinder gas production.


Slide 9 * Quantity of bio-waste to be supplied depends upon the size of the plant.
  • Too much bio-waste should not be fed into the digester.
  • This will lead to shorter retention time-
  • i.e. bio-waste will be in the digester tank for lesser time.
  • And fermentation won’t be completed.
  • Hence, bio-waste will come out in the slurry tank without being digested.


Slide 10 * If less bio-waste is fed into the digester, then gas production will be low.
  • Water condensation should be checked regularly.
  • As water in the pipeline will block the passage of gas.


Slide 11 * Do so by lifting the gas pipe so that the water can run back into the digester tank.
  • Also keep a check that the slurry is being pumped out smoothly into the slurry tank.
  • Ensure that the slurry is being emptied out of the slurry tank when it is full.


* No inflammable items like-

lighter and/or cigarettes should be brought near the outlet pipe of the dome.

Slide 12 Another important thing to be done is that-
  • Slurry in the digester tank should be completely removed once in three years.

This is usually done by the mason himself.

[[Image:]] As shown, keep the mixing tank and the slurry tank covered.


This is done to ensure proper hygiene and to avoid breeding of mosquitoes near the plant.

Slide 13

Repair section

Image of a technician

Let us now look into the Repair section.


Repair of Biogas burner should always be done by a qualified technician.

[[Image:]]


What you see here is a Biogas burner with the flame.
[[Image:]]

[[Image:]]

[[Image:]][[Image:]]

To start repairing, first switch off the inflow of gas by turning off the knobs on-
  • the hose pipe and
  • at the burner

Doing so is very important.



[[Image:]] What you see here is the burner without the flame after the knobs have been turned off.


Wait for few minutes and light the burner to ensure that gas inflow has stopped.

[[Image:]]


[[Image:]]

Now remove the hose pipe connected to the burner.


Do so by loosening the Vohj clip tightened on the hose pipe connected to the burner.


Once it is loosened, pull out the hose pipe.

[[Image:]] Now place the hose pipe near your ear to check for the sound of gas.


No sound means no gas inflow and the repair work can be carried out safely.

[[Image:]]

[[Image:]]


Now we start dismantling the burner.



[[Image:]] Next we will remove the debris in the burner.


As shown in the image, blow air through the hose-burner connector.


This will also help to check if air is reaching smoothly to the flame ring.

[[Image:]] Slightly tap the burner and then turn it upside down.


You can see the debris fallen from the burner.

[[Image:]] In case of hard debris which cannot be removed by blowing air, a dry scrubbing pad can be used.
[[Image:]] To clean the flame ring, use a pin and insert it into the holes for cleaning.


A ring with clean holes will ensure-


  • smooth flow of gas and
  • fuller flame


[[Image:]] A clean ring will look like this.



Slide 14


Apart from what is mentioned, periodic inspection of the plant is necessary.


Inspection will help to locate cracks on the surface of the digester tank.


Otherwise, the generated Biogas can escape into the atmosphere through these cracks.


Hence, these cracks need to be sealed quickly.

Slide 15 Once in 3 years,
  • the mason also repaints the inner wall of the digester tank
  • by using White cement and synthetic resin adhesive mixture to seal cracks, if present.


Slide 16 To make this mixture use the following-
  • 2 Ltrs of water,
  • 250 gms of Synthetic Resin Adhesive and
  • 2 kgs of white cement

Mix these thoroughly. And use.

Slide 17

Summary

Let us summarize:


In this tutorial we learnt about the maintenance and repair of the Biogas plant.

Slide 3

Acknowledgements

This video was created by:

Spoken Tutorial Project with inputs from Rural-ICT team, IIT Bombay.

This video was created by-

Spoken Tutorial Project with inputs from Rural-ICT team, IIT Bombay.

More information on these projects can be found at these links

http://spoken-tutorial.org/NMEICT-Intro

http://ruralict.cse.iitb.ac.in/ in

More information on these projects can be found at these links.

http://spoken-tutorial.org/NMEICT-Intro

http://ruralict.cse.iitb.ac.in/ in

Pictures and technology support:

Courtesy:

Bhagirath Rural Development Foundation

Village- Zarap, Taluka- Kudal,

Dist.- Sindhudurg

Pictures and technology support:

Courtesy:

Bhagirath Rural Development Foundation

Village- Zarap, Taluka- Kudal,

Dist.- Sindhudurg

This is Bella Tony along with the animation team of the Spoken Tutorial project signing off.

Thank you for joining.

Contributors and Content Editors

Bellatony911, Nancyvarkey